以下内容来自OCR识别，不保证本文准确性。完整文件请预览PDF

DRAFT FOR DEVELOPMENT

DD CEN/TS1992-4-4:2009

Design of fastenings for use in concrete

Part 4-4: Post-installed fasteners-Mechanical systems

ICs: 21.060.99: 91.080.40

NO COPYING WITHOUT BSI PERMISSION EXCEPT AS PERMITTED BY COPYRIGHT LAW

British Standards DD CEN/TS1992-4-4:2009

National Foreword

This Draft for Development is the UK implementation of CEN/TS1992.4-4:2009. This publication is not to be regarded as a British Standard. It is being issued in the Draft for Development series of publications and is of a provisional nature. It should be applied on this provisional basis, so that information and experience of its practical application can be obtained. Comments arising from the use of this Draft for Development are requested so that UK experience can be reported to the international organization responsible for its conversion to an international standard.

A review of this publication will be initiated not later than 3 years after its publication by the international organization so that a decision can be taken on its status. Notification of the start of the review period will be made in an announcement in the appropriate issue of Update Standards. According to the replies received by the end of the review period, the responsible BSI Committee will decide whether to support the conversion into an international Standard, to extend the life of the Technical Specification or to withdraw it.

Comments should be sent to the Secretary of the responsible BSI Technical Committee at British Standards House, 389 Chiswick High Road, London W4 4AL. The UK participation in its preparation was entrusted to Technical Committee B/525/2, Structural use of concrete. A list of organizations represented on this committee can be obtained on request to its secretary.

This publication does not purport to include all the necessary provisions of a contract. Users are responsible for its correct application. Compliance with a British Standard cannot confer immunity from legal obligations.

Amendments/corrigenda issued since publication was published under the authority of the Standards Policy and Strategy Date Comments Committee on 30 June 2009. ISBN 9780580626388